Popular Searches:

drugs

viagra

diet pills
drugs prescription drugs weight loss drugs drugs online discount drugs drugstore drugs for depression online drugstore online drugs canadian drugs cheap drugs nc drugs facilities fertility drugs canada drugs brands only drugs acyclovir adipex ambien antibiotic carisoprodol celebrex didrex diet pills discount xenical hydrocodone ionamin lortab meridia online soma paxil penis enlargement phentermine prevacid prilosec propecia prozac renova retin-a senior health soma sonata tenuate tramadol ultram valium valtrex vaniqa viagra vicodin vioxx vitamin wagering weight weight loss wellbutrin women health xanax xenical xenical online zocor zoloft zovirax zyban zyrtec
A1, A2, B, C1, C2, D, E, F, G-H, I-K, L, M, N, O, P1, P2, Q-R, S, T, U-V, W-Z

Unasyn Patient, Information, Instructions - Ampicillin and Sulbactam

Unasyn Patient, Information, Instructions - Ampicillin and Sulbactam INFORMATION FOR PATIENTS

INSTRUCTIONS FOR USE OF THE ADD-Vantage® VIAL

To Open Diluent Container:   Peel overwrap from the corner and remove container. Some opacity of the plastic due to moisture absorption during the sterilization process may be observed. This is normal and does not affect the solution quality or safety. The opacity will diminish gradually.

To Assemble Vial and Flexible Diluent Container: (Use Aseptic Technique)

  1. Remove the protective covers from the top of the vial and the vial port on the diluent container as follows:
    1. To remove the breakaway vial cap, swing the pull ring over the top of the vial and pull down far enough to start the opening , pull the ring approximately half way around the cap and then pull straight up to remove the cap
      NOTE: Do not access vial with syringe.
    2. To remove the vial port cover, grasp the tab on the pull ring, pull up to break the three tie strings, then pull back to remove the cover.
  2. Screw the vial into the vial port until it will go no further. THE VIAL MUST BE SCREWED IN TIGHTLY TO ASSURE A SEAL. This occurs approximately 1 / 2 turn (180°) after the first audible click. The clicking sound does not assure a seal, the vial must be turned as far as it will go.
    NOTE: Once vial is sealed, do not attempt to remove.
  3. Recheck the vial to assure that it is tight by trying to turn it further in the direction of assembly.
  4. Label appropriately.

To Prepare Admixture

  1. Squeeze the bottom of the diluent container gently to inflate the portion of the container surrounding the end of the drug vial.
  2. With the other hand, push the drug vial down into the container telescoping the walls of the container. Grasp the inner cap of the vial through the walls of the container.
  3. Pull the inner cap from the drug vial. Verify that the rubber stopper has been pulled out, allowing the drug and diluent to mix.
  4. Mix container contents thoroughly and use within the specified time.

 

top


Popular Searches:

weight loss

ultram

penis enlargement

hydrocodone

antibiotic